Amanco Pulley

Discussion in 'Parts/Engines Wanted' started by ellsengines, Dec 7, 2007.

  1. ellsengines

    ellsengines New Member

    Hi all
    an Amanco pulley is still needed for my engine, if anyone has one could they get back to me asap as i will need one for a little show in january.
    Many thanks
    Elliot
     
  2. TangyeDan

    TangyeDan Active Member

    Elliot,
    A few more details would help others to help you... Required internal diameter is 1 3/8" as discussed elsewhere, it would be good if you could let us know the amount of crankshaft there is protruding to fit it onto. I may have something, will have a look in the shed tomorrow.

    Regards

    Dan
     
  3. ellsengines

    ellsengines New Member

    an original amanco pulley would be what i am after really, but will measure the protruding crankshaft tomorrow as i would like the pulley to have a flush fit with the end of the shaft.
    if you could get me a pic of whatever you have in your shed i would be greatful.
    cheers
    Elliot
     
  4. TangyeDan

    TangyeDan Active Member

    Elliot,
    Not got a genuine Amanco pulley, but there's a couple of D-type 1.5" ID pulleys that could be sleeved, or a couple of 1 1/4" that could be bored out if you can't find a correct item. Let me know off list if they are any use.
    Regards
    Dan
     
  5. air-cooled

    air-cooled Member

    Hi Elliot, I have an Amanco pulley for the 2 1/4 or 2 1/2 hp engine if you still need one. It is 1 3/8 inch shaft, 6 inches diameter and 4 1/4 inches wide, 4 spoke type, boss fits flush with end of shaft on exhaust side of engine. Price not cheap. PM me if you are interested. AC.
     

Share This Page