ML Lister Magneto questions

Discussion in 'Help Wanted' started by campingstoveman, Feb 1, 2009.

  1. campingstoveman

    campingstoveman Active Member

    Gentlemen,

    After a little up cock on my part, drilled out bolt with thread clearance not tap size, I am now reassembling the magneto and have hit a tiny snag. What thickness of gasket should I use on front of mag as I ruined the old one getting it apart and forgot to measure it before I binned it, I know its critical because it must be correct otherwise you will have to much play in the bearings or not enough.

    Martin P

    p.s. Have checked to the best of my abilities spelling and Grandma
     
  2. lambe

    lambe Member

    try getting the old one out of the bin! or is that to easy?
     
  3. campingstoveman

    campingstoveman Active Member

    Took apart last weekend, dustmen been since then.

    Martin P
     
  4. petternut

    petternut Administrator

    Unless you can rig up a DTI to measure the end float, it'll be a case of trial and error. IIRC you should have a few thou end float.
    You'll also probably need it re-magnetising.

    hth
    Roland
     
  5. campingstoveman

    campingstoveman Active Member

    I had better get my finger out then and do what was taught to do many, many years ago. I will allow a few thou. I've even considered a thin smear of silicon sealer to give the gap as long as there is no pre load.

    Martin P
     
  6. brokencrank

    brokencrank Member

Share This Page